The AS-1 Line on a Windshield

Many state tint laws refer to the AS-1 line on a windshield. The term comes from the federal glazing standard, and this page explains what the federal text says about it.

Read the sources. Parts of this guide were read from summaries of the linked sources and could not be confirmed word for word. It explains a general concept and is not legal advice. Check the sources linked below, and your state’s own page, before relying on any detail.
Key facts
Federal rule
FMVSS 205, 49 CFR 571.205
Incorporated standard
ANSI/SAE Z26.1-1996
Where the CFR names AS-1
S5.4: low speed vehicle windshields meet AS-1 or AS-4 glazing specifications
Manufacturer marking
DOT plus NHTSA-assigned manufacturer code

Where the term comes from

AS designations such as AS-1 are glazing categories used in ANSI/SAE Z26.1-1996, the industry standard that Federal Motor Vehicle Safety Standard 205 (49 CFR 571.205) incorporates by reference. The CFR text itself does not define AS-1; its definition sits in the incorporated standard, which was not opened for this page.

The CFR does mention AS-1 once in the sections reviewed: windshields of low speed vehicles must meet the ANSI/SAE Z26.1-1996 specifications for either AS-1 or AS-4 glazing.

Markings on glass

FMVSS 205 requires prime glazing manufacturers to certify their glazing and mark it with the letters DOT plus a manufacturer code assigned by NHTSA, following the marking section of ANSI/SAE Z26.1-1996. The regulation also contains a correction about the placement of arrows in the AS markings.

Those markings are made by the manufacturer on the glass. They are separate from any film applied later.

How state tint laws use the term

Some state statutes allow tint on the upper part of the windshield only down to the AS-1 line, and others use a fixed measurement or a stated strip instead. Each state defines its own rule, so the state windshield rows on this site give the wording and numbers from that state's statute.

This page does not state where the line sits on a given vehicle or what a state allows above it.

Sources

Last checked October 2026. RulesByState is informational only and not legal advice.

Frequently asked questions

Is the AS-1 line defined in the CFR text?

Not in the sections reviewed. The CFR refers to AS designations through ANSI/SAE Z26.1-1996, which it incorporates by reference.

Do all states use the AS-1 line?

No. States word their windshield tint rules differently; check the state page and its statute.

Is the AS-1 marking added by tint installers?

Under FMVSS 205, certification and marking are the glazing manufacturer's responsibility.

Find a state rule